- TRAILERS & TRAILER REPAIRS
- TRAILER PARTS
- VIDEOS AND ARTICLES
- CONTACT US
The tow ball load is the amount of weight the fully loaded trailer vertically imposes in the tow bar of the towing vehicle.
If you have a compliance plate on your trailer (all trailers built after August 1989 must have a compliance plate) will list the trailers GTM (Gross Trailer Mass). The difference between the ATM and the GTM will be the trailers ball load.
Just like all other towing specifications, the ball load must not be exceeded.
If you own a small trailer than the ball load is not usually a issue with your towing unless your towing vehicle has a low ball load specification. This can be the case with many small vehicles and some European vehicles. Heavier trailers such as horse floats and caravans can often place a heavy ball load onto the towing vehicle.
The ball load is a function of the trailers position and the way that the trailer is loaded
We can be measure the ball load of your trailer on our weighbridge. This can be done in 2 ways.
1. When at the weighbridge, disconnect the fully loaded trailer from the towing vehicle and place only the trailers drawbar (via the jockey wheel) on the weighbridge scale.
2. Place your fully loaded trailer completely onto the weighbridge. 2 weights will be recorded - one while the trailer is still attached to the towing vehicle and one after unhitching the trailer. By subtracting the hitched weight from the unhitched weight you will know how much weight is being imposed on your tow ball and also how heavy your fully loaded trailer weights.
The ball load is often approximately 10% of the trailers ATM but you should not rely on this "guessed" weight for every trailer. The best way to determine the ball load is always to use a weighbridge to check that you are complying with your trailers and towing vehicles specifications.
We are excited to announce that we have just had a Trade Certified Weigh Bridge installed at the Bold Trailers workshop located at 5 Captain Cook Drive, Caringbah NSW 2229.
Bold Trailers can now provide weigh bridge tickets for registration requirements for your vehicle or trailer.
The weigh bridge will be open 5 1/2 days a week during normal trading hours for Bold Trailers.
Weigh Bridge tickets are needed for the registration of unregistered vehicles in NSW. This can include vehicles and trailers that have run out of rego, new vehicles and trailers that have never been registered, vehicles and trailers that have been modified and imported vehicles and trailers that need to be registered in NSW.
You can also use a weigh bridge to check if the boat and trailer combined load does not exceed your trailers maximum towing capacity.
The picture below is of Christian with our certification paperwork for the weigh bridge - and by the way - wasn't it nice that the weigh bridge was painted in Bold Trailers yellow.